Replacement for DTS92 Evohome thermostat
Posted: Fri Aug 16, 2024 6:32 pm
Hi all, the DTS92 wireless thermostat that I use to control my kitchen underfloor heating as part of my Evo home setup has died. I’ve ordered a new DT4R replacement (apparently this is the newer model)
My question is how do I bind this into the system when it is delivered - I’ve had binding nightmares before.
Do I just bind it into the touchscreen controller?
Or do I bind it direct to the HCC80R underfloor ?
Or do I bind it to the BDR91 controller connected to the boiler?
It’s so long since I set the system up I can’t remember the binding sequence but do recall it was very important!
Any help much appreciated
My question is how do I bind this into the system when it is delivered - I’ve had binding nightmares before.
Do I just bind it into the touchscreen controller?
Or do I bind it direct to the HCC80R underfloor ?
Or do I bind it to the BDR91 controller connected to the boiler?
It’s so long since I set the system up I can’t remember the binding sequence but do recall it was very important!
Any help much appreciated