The Efficient Home Forum

Hi all

I'm steadily working towards building load compensation from Evohome to my Bosch EMS boiler.

I think the ideal would be to emulate the Bosch OpenTherm bridge device via a microcontroller board, but in the short term I'm looking at monitoring the Evohome messages via my HGI80 to infer a load level to pass to the boiler via a BBQKees EMS interface over HTTP (or similar).

Is anyone ahead of me on this? I couldn't find much here or elsewhere.

There will be more information on the Automated Home Forum than there will here.

The EVOHOME Shop wrote:There will be more information on the Automated Home Forum than there will here.

Thanks - I'll try and feedback any key findings.