Page 1 of 1

New features description- firmware 02.00.19.33

Posted: Fri Apr 16, 2021 10:07 am
by pbrud
Hi All,
I finally received new firmware and I noticed new features as below:
1. Advanced Load scaling in "deep" configuration settings
2. Cold Weather Boost in Optimisation
3. Warm Weather Saver in Optimisation

I think I understand algorithm of Cold Weather Boost. If the difference between set temperature and outside temperature will be higher that set in configuration, set temperature will be increased by defined step.
Warm Weather Saver seems to work in opposite way, but with no possibility to set parameters. If there is warm outside, than number of requests for energy should be reduced. Does anybody know the algorithm?
Advanced Load Scaling - to be honest I have no idea how it works. I turned it on and I see no difference. Anybody?:-)

Re: New features description- firmware 02.00.19.33

Posted: Wed Apr 21, 2021 5:51 pm
by Nabys
pbrud wrote: Warm Weather Saver seems to work in opposite way, but with no possibility to set parameters. If there is warm outside, than number of requests for energy should be reduced. Does anybody know the algorithm?
I’d like to know that as well because I can’t figure out how it works.

All my zones have WWS enabled. But only some seem to use it. WWS kicks in once the outside temperature reaches 15C (I think), but only two or three zones will activate WWS. The rest will happily do their thing, even if the room temperature is well above setpoint and there is no need for heating.

Re: New features description- firmware 02.00.19.33

Posted: Sun Apr 25, 2021 6:25 pm
by antsals
Quick question......how do I know if I have a G3000 unit? I have the WiFi version but is WiFi 02.00.17.00 and Application 02.00.17.03. I'm based in the UK...never had an option to update the firmware.

How can I check if I should have got the update?

Cheers,
Ant

Re: New features description- firmware 02.00.19.33

Posted: Mon Apr 26, 2021 8:15 am
by Richard
antsals wrote:Quick question......how do I know if I have a G3000 unit? I have the WiFi version but is WiFi 02.00.17.00 and Application 02.00.17.03. I'm based in the UK...never had an option to update the firmware.

How can I check if I should have got the update?

Cheers,
Ant

If you have the Wi-Fi version, you will have a G3000 controller (which is the end of the controller part code under the front flap - ATC928GXXXX). :geek: