Re: adding HR80UK valve
Posted: Tue Dec 08, 2020 4:54 pm
OK, so I imagine you are sorted but this is how it should be done. 
Firstly clear the HR80 binding...
Then this on the first device (only if you want this HR80 to be your room sensor)...
Then this is the bit that everyone misses... If you have 2 or more HR80's in the same zone, you need to put them all in bind mode...
Hope that helps?
Firstly clear the HR80 binding...
- hr80uk reset proceedure.JPG (39.35 KiB) Viewed 182 times
- hr80 pairing page 1.JPG (66.37 KiB) Viewed 182 times
- hr80 binding page 2.JPG (58.66 KiB) Viewed 182 times