adding HR80UK valve

All Honeywell Home evohome general discussion in here! *PLEASE NOTE* Official Resideo technical support is on 0300 130 1299.
Post Reply
User avatar
Richard
Site Admin
Posts: 1199
Joined: Fri Jun 10, 2016 4:08 pm
Location: Mid Wales
Contact:

Re: adding HR80UK valve

Post by Richard »

OK, so I imagine you are sorted but this is how it should be done. :geek:

Firstly clear the HR80 binding...
hr80uk reset proceedure.JPG
hr80uk reset proceedure.JPG (39.35 KiB) Viewed 175 times
Then this on the first device (only if you want this HR80 to be your room sensor)...
hr80 pairing page 1.JPG
hr80 pairing page 1.JPG (66.37 KiB) Viewed 175 times
Then this is the bit that everyone misses... If you have 2 or more HR80's in the same zone, you need to put them all in bind mode...
hr80 binding page 2.JPG
hr80 binding page 2.JPG (58.66 KiB) Viewed 175 times
Hope that helps? :geek:
Home: 2012 Built Oak & Timber Frame Home (EPC Score 95 - A Rated)
Renewable Tech: GSHP, Solar Thermal, Solar PV & 20kWh Battery Storage
Smart Home Platform: Home Assistant, Shelly & Salus Smart Home
Post Reply