Set Controller as Temperature Sensor for Zone After Setup

[robbieduncan]

I have my system setup and running. Right now the controller is on the desk stand in the kitchen-diner. It is not in a suitable place to use as the temperature sensor in that room and as I knew it would not be staying there I did not set it up that way. I am just making good after installing the wall mount in the hallway. This is a good location to use the controller as the sensor for that zone, certainly better and more stable that then HR92 on the radiator.

So the question is how do I set the controller as the temperature sensor for that zone without using guided configuration and re-doing all the zones. That would take quite some time with 11 zone, some of which have single-zone wall stats and some have multiple radiators. When I buy a new single-zone wall stat I can easily rebind the devices in just that zone and bind the wall-stat as the temperature sensor. However I don't see an option to set the controller as the temperature sensor.

[Bart]

I believe you can enter the installer settings menu, enter zone settings, select the zone, select temperature sensor settings and choose the evotouch.

[Richard]

I believe you can enter the installer settings menu, enter zone settings, select the zone, select temperature sensor settings and choose the evotouch.

As Bart said... This is of course unless you have already accidentally assigned it to a zone already.

[robbieduncan]

Thanks, that looks perfect