The Efficient Home Forum

Hello all

I have a HR92 on a radiator, but the radiator has a cover, so the original installer recommended a DT92e room thermostat. So... I know how to bind the HR92s to the boiler but I don't know the setup for a HR92 and a DT92e in the same room. Do I need to bind the HR92 radiator valve to the DT92e and then bind the DT92e to the boiler receiver? I don't get how the setup needs to work in order to have the DT92e act as the thermostat and then also trigger the HR92 to actually change the radiator.

Thanks

Very important that when you do things on the evohome Controller that you actually follow the evohome Installation Guide - https://www.honeywelluk.com/documents/A ... lation.pdf

Page 14 of the evohome Installation Guide details how to pair a HR92 to the evohome Controller... But instead of using the HR92 as the sensor for the zone, you would pair the DT92E instead and the HR92 would then be paired as the actuator on the next menu.