The Efficient Home Forum

Dear All,

I just purchased ATP928 plus some valves. I would like to ask if anybody have experiance about IFTT?
I registered and activated some IFTT applet (tipically if i left a location then turn off heating, or change to echo mode...etc..) but non of the applet seems to work.


In the IFTT activity i can't see if any of the applet run... in the evohome IOS application i can't see any changes....

Is there any trick or something? Where should i start the investigation?

Any help apperitiated...

Regards,

Krisztián

Editing: As i see the location based applets not working. I tested a button based applet on my phone and its working well.

I use IFTTT and think IFTTT has been having some issues over the last few days... Either contact IFTTT using their contact form or call Honeywell on 0300 130 1299 to check if the Honeywell server is having issues.

I have used IFTTT with some success. As an example a button on my phone to cancel a quick Action. This is quicker than the App.

However the shame is that Evohome only works for Actions and cannot function as a trigger. So you can't take an action when the measured temperature falls below a value, for example send yourself a txt when the frost stat kicks in. I think only Honeywell can change this.