Mgomez2 wrote:Hello, I didn't understand how to install 2 or more HR92 in the same room.
First I have connected the first hr92, but I don't know how to add the second hr92.
Can you help me?
Thnaks
From the Installation Guide:
Bind the Radiator Controllers (HR92)
1 Remove the circular top cover
2 Open the battery clip and insert the AA batteries supplied
3 Close the clip and replace the cover
4 Press the button once − it should say UNBOUND
5 Press and hold the button for a further
5 seconds until it says BIND
6 Press the button once – it should say BINDING
7 You should receive a SUCCESS message on the
evohome Controller (if not go back and re-bind)
8 The name of the allocated zone should appear on
the HR92 display when you press the button
9
Either press the green tick to add another
radiator to the zone. Or press the red cross if
you don’t need to add another radiator to the zone
NB. The first bound HR92 will act as the temperature sensor for the zone so avoid using a HR92 behind a curtain or furniture for this purpose. Both HR92s will show the zone target temp (if this has been set up in the HR92 menu).
Edit:
I have given you the answer to adding two or more HR92s to a single zone; however, if your question was related to 'how to add rooms to a multi- zone' (e.g.; you want the bedrooms on the same temps and timings), then this link might help:
http://www.automatedhome.co.uk/vbulleti ... =multiroom
From the old installation guide:
evohome allows you to create a zone with multiple rooms
(i.e. Bedroom's) that are controlled together as one group.
It does this by letting all the radiator controllers bound to
that zone to independently measure room temperature and control a radiator. This means you can locate the radiator controllers in separate rooms without them all being controlled by one temperature sensor like a single room zone does.
To create a multiple room zone either:
•
•
Add a new zone and bind the radiator controllers for all the rooms. Go to the parameters
menu and select multiple room zone.
or
Go to Zone Configuration and edit an existing zone's parameters. Any bound radiator controllers already bound to that zone will now work independently