EVOHOME Heating and Hot Water System.

[Devon Red]

Hi,
Just completed a new EVOHOME installation, controlling both the Central Heating and the stored Hot Water systems.
The system uses a mid port valve (Honeywell Y Plan).

When the demand is for Heating, the appropriate BDR91 is energised (green).
When there is call for Hot Water only, both the BDR91s are energised.

Is this correct?
I was expecting only the Hot Water BDR91 to be energised.
I have followed both the installation guides and YouTube videos, with the same result.

Any help gratefully received.

[Richard]

Your evohome system has not been setup correctly for the heating system type you have got. Unless you have a 3x wireless relay system (oil boiler for instance) then you should not be using a 'boiler control' relay with a Y Plan system.

As you are a customer of ours, you can have access to our customer help videos. This one will help in particular - http://theevohomeshopforum.co.uk/viewto ... ?f=12&t=29

You need to set 'BOILER CONTROL' to 'NONE' under the 'SYSTEM DEVICES' tab in the 'INSTALLATION MENU' (press and hold 'SETTINGS' button for +3 seconds) before following my video.

I hope that helps.

Thanks,

Richard

[samg18]

Good afternoon, I think I may be experiencing the same issue, I have y plan mid position valve with two bdr wireless relays one for hotwater one for heat.
The link to to video says page not found.
Any help would be great.

Sam

[Richard]

Hi Sam,

I have updated the link, as we had to change servers but all the videos are in the videos section.

Thanks,

Richard