adding HR80UK valve

[Richard]

OK, so I imagine you are sorted but this is how it should be done.

Firstly clear the HR80 binding...

hr80uk reset proceedure.JPG (39.35 KiB) Viewed 181 times

Then this on the first device (only if you want this HR80 to be your room sensor)...

hr80 pairing page 1.JPG (66.37 KiB) Viewed 181 times

Then this is the bit that everyone misses... If you have 2 or more HR80's in the same zone, you need to put them all in bind mode...

hr80 binding page 2.JPG (58.66 KiB) Viewed 181 times

Hope that helps?