Hi everyone. I bought my Evehome last week and been using it with four radiator controllers. One controller is placed in the living room keeps causing the Evohome monitor to show an error comms message as showing in the attached photo. I tried the these troubleshooting steps with no luck to fix the issue:
1. Reset the controller settings.
2. Unbinding and rebinding after clearing the connection with the Evohome monitor.
3. Remove the battery for few seconds after resting the settings.
4. Delete the zone and create new zone then rebind the controller.
After doing the steps above, and create new zone, the system would work for few hours then same error appears.
Interestingly, the controller and the eveohome monitor keep communicating properly (two way communication) despite the error message that keeps pooping up every time I click the living room zone.
Any idea what to do? not sure if the controller is defected or I'm missing something.
Thanks.
Controller (HR92) comms fault actuator - HELP
Controller (HR92) comms fault actuator - HELP
- Attachments
-
- Error 2.jpg (82.97 KiB) Viewed 730 times
Re: Controller (HR92) comms fault actuator - HELP
Did you clear the fault log under 'SETTINGS'?
Home: 2012 Built Oak & Timber Frame Home (EPC Score 95 - A Rated)
Renewable Tech: GSHP, Solar Thermal, Solar PV & 20kWh Battery Storage
Smart Home Platform: Home Assistant, Shelly & Salus Smart Home
Renewable Tech: GSHP, Solar Thermal, Solar PV & 20kWh Battery Storage
Smart Home Platform: Home Assistant, Shelly & Salus Smart Home
Re: Controller (HR92) comms fault actuator - HELP
Thanks a lot. It's always the straightforward solutions that got overlooked. I cleared the log and it's good for a couple for days now.
Re: Controller (HR92) comms fault actuator - HELP
No problem, glad I could help...Samo wrote:Thanks a lot. It's always the straightforward solutions that got overlooked. I cleared the log and it's good for a couple for days now.
Home: 2012 Built Oak & Timber Frame Home (EPC Score 95 - A Rated)
Renewable Tech: GSHP, Solar Thermal, Solar PV & 20kWh Battery Storage
Smart Home Platform: Home Assistant, Shelly & Salus Smart Home
Renewable Tech: GSHP, Solar Thermal, Solar PV & 20kWh Battery Storage
Smart Home Platform: Home Assistant, Shelly & Salus Smart Home
-
- Posts: 1
- Joined: Fri Mar 08, 2024 10:53 am
Re: Controller (HR92) comms fault actuator - HELP
Thanks for this ! Just worked for me (after spending a few hours trying to debug, thankfully not resetting or re-binding).
Bit counter intuitive that after a reboot of the controller that errors still show when they aren't actually present..
Bit counter intuitive that after a reboot of the controller that errors still show when they aren't actually present..