The Efficient Home Forum

I've also sent this as an email to evohomeshop. I've got an Intergas Xclusive 30 being installed with Evohome using the OpenTherm Bridge, the circuits are set up with two zone valves in X Plan. The Megaflow cyclinder stat has been replaced by the Honeywell Insertion Stat connected to a CS92, and ...

Yes thanks, the X Plan document was excellent, is there a similar one for the Pin 5 setup? Looking at the cylinder it's from RM Cylinders and is a 900mm by 450mm cylinder, their closest current range have between a 10kw and 12kw coil they say. https://www.jouleuk.co.uk/knowledge-centre/?_sf_s=rm ...

The system is an Intergas HRE 18 SB set up using Opentherm and wired as X Plan with a single BDR91 controlling the NO (CH) and NC (HW) valves. When the CH demand is there then the system runs fine, the boiler kicks in and runs at the required level for the CH demand, when temperature is reached then ...

Thanks, and yes I logged a call through the Honeywell website this morning. Having just tested it in the last 5 minutes, mine is now (slowly) working again. I will wait for my reply from the service desk and if this was a know service outage will suggest they add a service monitor on their website ...

I realise I must have done something silly but have spent some time and can't work out what it is. My system is an Evohome controller with 12 zones and a separate gateway which has worked well for a number of years. I usually control zone temperatures through my Android phone and the Total Connect ...